Eye wash station|safety shower|eyewash and shower station
DAAO6615-X Anti-freeze Emergency Shower and Eye Wash Station Auto Emptying Foot Pedal
Views:472 ClassificationAnti-freeze Emergency Shower and Eye Wash Station
1. Material: The main body is authentic 304 stainless steel.
2. Shower: Pull down the lever, the shower water will be ejected from the shower basin within 1 second, the shower flow is ≧75.7L/min.
3. Eyewash device: push the handle away, the aerosol eyewash is sprayed out within 1 second, the height and angle of the water are designed according to the proportion of the human face, and the eyewash flow rate is 11.4L/min. Working pressure 0.25-0.4MPA.
4. Eyewash filter: high-density PP+ four-layer 304 stainless steel mesh interlaced filter, which can filter fine impurities in the water, and the sprayed water is aerosol-like, embraced and gentle.
5. Ball valve: The two-piece ball valve can make the eyewash's effluent flow accord with American standards.
6. Eye-washing device assembly: 304 castings are made of finished products, of which 90-degree elbows are made of seamless tubes, without welds, and will not burst the wall of the tube due to water pressure during use.
7. Shower basin: diameter 260mm, thickness 0.6mm, the arc is tangent by two smooth curves of R250 and R39 respectively, so that the shower water spreads on the inner wall of the shower basin along the arc, just at the height of 1524mm, reaching The coverage of 508mm in diameter fully meets the requirements of the American standard for the scope of eyewash flushing.
- Model: DAAO6615-X
- Height: 2410mm
- Material: 304 / 316L stainless steel
- Tube wall thickness: 2.5/3mm
- Working pressure: 0.2MPa-0.6MPa
- Working environment temperature: -5℃ -35 ℃
- Water inlet size: NPT 1 1/4 ”
- Drain size: NPT 1 1/4 ”
- Eyewash flow: ≥11.4L / min
- Body flow: ≥75,7L / min
- Main functions: eye wash / flush, automatic emptying, antifreeze
- Standard: ANSIZ 358.1: 2014, EN15154.1 / 2: 2006
The antifreeze-type composite eyewash can use the combination of a valve at the bottom, an automatic reset device, and use gravity to automatically drain water from the pipe after use, thereby avoiding icing in the pipe when the ambient temperature is below zero degrees. which suitable for cold areas where the temperature is below freezing in winter.
Shower Head
Based on the American standard requirements and our unique design, one time stamping molding shower head have total 94 holes and the edge is half hole which can create the perfect water spay area.
-One time stamping molding
-ABS plastic combine with seamless 304 stainless steel and 3 layers filter
-Flag handle: bright yellow. Easy to recognize from far distance.
Pipe &Pull Rod
Good quality 304 stainless steel tube content with more than 8% nickel. Both inside and outside is finished with fine polishing.
Capable of Self-standing and have 4 bolts for extra fix needed
Auto emptying the water in the pipe after use
Protect the pipe from freeze in the winter and prevent the potential water deterioration
Material Carbon steel + ABS coating.
Non-slip design for the foot pedal
Packing
Wrap with bubble film and packing into the fumigation free wooden crate
