Some tips for using eyewash

Eyewash is an indispensable device for safety and labor protection. It is an emergency and protection facility necessary for contact with toxic and corrosive substances such as acids, alkalis and organics. During installation, try not to bump the nozzle of the eyewash with hard objects to avoid damaging the surface gloss. Pay attention to remove the debris in the pipe and install the nozzle of the eyewash.

Under the condition that the water pressure is not lower than 0.2mpa, after using for a period of time, if you find that the amount of water is reduced, or even the water heater is turned off, you can get the water outlet on the nozzle of the eyewash and gently unscrew the sunscreen cover to remove In addition, do not use excessive force to switch the ball valve, just turn it gently, and do not screw it. Do not use the handle as a handrail. Eyewash should pay attention to daily maintenance, so as to increase the service life.

Pay attention to the following points when using eyewash:

1. When rinsing other parts of the body, pull down the valve rod by hand, and water will automatically spray from the shower head. After use, the rod must be reset upwards.

2. Eyewash is used in emergency situations to temporarily alleviate the harmful effects of harmful substances on the body, further treat and treat, and follow the instructions of doctors.

3. When the eyewash is used, as long as the eye is flushed, push the hand-push valve gently, and the clean water will automatically spray from the eye-wash nozzle. After use, you must reset the hand-push valve and reset the dust cover.