Installation procedure of eye washer

31. Unpack and check all parts.

2. Place the components from top to bottom according to the installation diagram to avoid confusion caused by random placement.

3, start the installation, the order is from the bottom to the top, although strictly speaking, each part of the installation should be pressed to test the water once, but the eye wash produced by Shanghai Hong ‘an Safety Protection Products Co., Ltd. has been strictly pressed to test the water, so the step can be omitted.

4. Fix the base.

5. Calibration.

6. Trial (Shanghai Daao Safety eye wash manufacturer will test the water before leaving the factory, and it can be used directly after installation in general)

In order to avoid affecting the service life of the eye washer, the eye washer should be installed at the corner of the wall and near the site, and the hand push plate should not be too strong.